• Download Life and AIM Data and Upload to Applicable Drive Location
• Change Engine Oil (Visually Inspect Drain Plug. Record Findings)
• Change Oil Filter
• Service Air Filter
• Change GDU Oil (Visually Inspect Drain Plug. Record Findings)
• Check Air Block and Lines for Leaks
• Check Paddle Shifter Screws for depth and Threadlocker
• Check and Adjust Clutch
• Change/Cycle Brake Fluid through System, and Bleed Calipers
• Torque Bleeders 
• Check and Document Brake Rotor Wear and Condition
• Check and set Brake Bias to Apex Baseline
• Verify Race Alignment to Apex Baseline
• Corner Balance to Apex Baseline (5 Gallons of Fuel)
• Set Splitter Height to 40mm
• Verify Wing settings
• Verify Rub Block Wear Patterns
• Verify Nut & Bolt Torque to Specs
• Start Car, Verify Engine Parameters
• Torque Wheels (Apply Anti-Seize to Mating Surfaces)
• Verify Functionality of all Body Fasteners
• Verify Integrity of Body Mounting Struts and Braces
• Clean Body Work
• Verify Dash Functionality
• Verify SmartCam Functionality

Includes:

Motul Synthetic 15W-50 300V Engine Oil, NEO Synthetic 75W-90 GDU Oil, Engine Oil Filter, Motul RBF 600 Brake Fluid, Radiator Coolant, Anti-Seize, Motul Wax GDU Lube, Filter Cleaner, Filter Oil and Waste Disposal.

Minor corrections necessary for any “Check or Verify ” inspection step is included unless the scope of correction is beyond reasonable means, at which point, the owner will be informed/notified of the issue and estimate to correct.

• 8 Hour Engine Oil and Filter Change (To Radical oil specs, per Engine Warranty)
• Hour Service, Oil and Filter Change and GDU Fluid Change
• Brake Rotor and Pad Inspection, With Measurement & Specification Reporting
• Brake Fluid Flush (Includes Inspection)
• Brake Pads, Remove and Replace with New (If done after inspection subtract inspect Cost)
• Brake Pads and Rotors, Remove and Replace, (New Replacement)
• Gear Ratio Change, Includes New Gear Set, Fluid and Gear Change Nuts, (ApexSpec Build Ratio, 3:23:1)
• Gear Ratio Change (Includes Fluid and Gear Change Nuts, Does not include the new Gear cost)
• GDU Service ($125/Hr, Plus Parts, Maximum $7,500 Total)
• GDU Fluid Change
• Fuel Injector, flow test and Cleaning
• Fuel Bladder, Inspection and Clean
• Fuel Pump Replacement
• Fuel Filter Remove and Install
• Fuel System Capacity Evaluation & Update, Designed to run at 2 gallons (Install Radical Update)
• Spark Plugs, Replace with New
• Air Cleaner, Replace with New
• Air Cleaner, Clean & Oil Existing
• Fire System Inspection
• Fire Bottle Fill or Replacement (With Core)
• Shifter, Air Block (Rebuild)
• Shifter, Air Block (New) (With Core)
• Shifter, Air Compressor Replacement
• Clutch, Inspect (Spin-safe or Manual)
• Clutch Adjust, Spin-Safe or Manual
• Clutch, Install New, Spin-Safe or Manual
• Clutch, Install New, Manual
• Half Shaft Service
• Cooler Replacement (Water) No Fluids (New Replacement Unit)
• Cooler Replacement (GDU) No Fluids (New Replacement Unit)
• Cooler Replacement (Oil) No Fluids (New Replacement Unit)
• Clean rubber and debris off body and Vacuum footbox
• TPS Remove and Install (Includes Sensor)
• GPS Remove and Install (Includes Parts and Oil)
• Engine, Remove and Install with new or rebuilt. (Labor Only)
  (Includes Oil, Filter, Oil cooler, and cleaning of Dry Sump Tank and Lines)
• Dyno of Engine, Per Hour (Baseline is 1.5 Hours)
• Labor, Diagnosis, and Crash Repair, Per Hour

• Seat, Fitted, Nomex Covered Energy Absorbing Bead with ID Embroidery
• Shift Light Array, Installed (Radical, CAN Based)
• Windscreen, (New Replacement) Apex and CUP Legal (Installed)
• Transponder, Hardwired and set up for Apex or any track
• Reposition Radical Head Surround
• Pedal Extension CRW-0105 Custom fitted, Maximum 2″
• Pedalbox, Install Move Kit, 3″, 4″ or 6″ P/N: CRW-01013

• Racing Radio, Installed in car with Antenna and 1 Crew Radio, Digital (Pit communications), 1 Helmet Wire for Communications
• 1-Way Race Receiver
• Helmet Wired for Communications
• Earbud, Sportsman (For Radio Comms)
• Earbud, Pro (For Radio Comms)
• Earbud, Custom Fitted Molding Kit (For Radio Comms)

• Wheel, Set (New Replacement) (Radical, SR3)
• New Set of Hankook Slick Tires, Inspect Wheels, Mounted, Balanced, Wheel
• Weights Taped and Takeoffs Disposed
• New Set of Hankook Wet Tires (Grooved for rain conditions) Inspect Wheels,
• Mounted, Balanced, Wheel Weights Taped and Takeoffs Disposed
• Powder Coat Wheels (Per set, wheels not included)

• Dyno Shocks, Supply 1, 3, & 10 ips graphs (Off Car, No springs)
• Dyno Match Settings
• Shocks, Adjustable, Set, New, With Springs and Bearings (New Replacement)(Includes Corner Balance and Installation)
• Spring Change (Includes new springs, bearings and Corner Balance)
• Nik Link Change (Includes New Link, Any size, & Corner Balance)
• Alignment, (Caster, Camber and Toe)
• Corner Balance with Ballast Change